Laminate Material - DataCard ImageCard IV User Manual

B-4

Laminate material

Use Datacard DuraGard® laminate material in the ImageCard IV printer if the printer
includes an optional overlay station. (Laminate is also called overlay.) Some material
types can only be used with the newer metal heated roller. The overlay station has a
light blue dot on it if it contains a metal heated roller. If you use 1.0 mil or 1.1 mil
laminate, you must also use composite (not PVC) cards because of the heat required
to apply 1.0 mil or 1.1 mil material.
i
The following describes the laminate materials you can use and the roller types
required:
DuraGard
0.6 mil
Holographic
Laminate
DuraGard
0.6 mil
Smart Card
Holographic
Laminate
Duragard
1.1 mil
Holographic
Laminate
Duragard
1.1 mil
Smart Card
Holographic
Laminate
DuraGard
1.0 mil Clear
Laminate
If the printer has an optional topcoat station, see
Name Part number
547562-001
547562-052
553269-003
553269-004
553277-101
"Topcoat material" on page
Heater roller
Either Die-cut polyester patches on a
carrier material with a tamper-
evident image.
About 300 uses.
Either Die-cut polyester patches on a
carrier material with a tamper-
evident image. Patch covers all
of the card except the area of the
smart card chip.
About 300 uses.
Metal only Die-cut polyester patches, 1.1
mil thick, on a carrier material
with a tamper-evident image.
About 250 uses.
Metal only Die-cut polyester patches, 1.1
mil thick, on a carrier material
with a tamper-evident image.
Patch covers all of card except
the area of the smart card chip.
About 250 uses.
Metal only Full-card die-cut polyester
patches, 1 mil thick, on a carrier
material.
About 250 uses.
User's Guide for the ImageCard® IV Printer
B-6.
Description