Changing The Laminate In The Overlay Station - DataCard ImageCard IV User Manual

Loading supplies
3
4
5
6
7

Changing the laminate in the overlay station

If your printer includes an optional overlay station, the station uses laminate supply
material.
This section describes the three steps of changing the overlay material:
•
•
•
E
User's Guide for the ImageCard® IV Printer
Take-up knob
Glide roller
Glide roller shaft
iciv040u
Figure 4-7: Replace the cleaning tape cartridge
Lower the cleaning tape cartridge into the printer.
Press down firmly to seat the cleaning tape cartridge in the printer.
Press down on the lock (step 2 in
in the printer.
E
On some cartridges, press down and turn the lock clockwise
cleaning tape cartridge.
Turn the take-up knob counterclockwise
Close the cover of the printer and press to latch it. If the printer has a lock, lock the
printer.
Remove the supply cartridge
Load material in the cartridge
Replace the supply cartridge
If you change the type of supply material you use, see
settings" on page 6-15 for more information.
2
1
1
Figure 4-7) to secure the cleaning tape cartridge
to remove any slack from the tape.
♦
"Changing operational
4-9
to lock the