Loading Supply In The Cartridge - DataCard ImageCard IV User Manual

Loading supplies

Loading supply in the cartridge

After removing the supply cartridge from the printer, remove the used material and
load new material.
Load supply in the cartridge
1
2
3
4
5
6
7
8
9
User's Guide for the ImageCard® IV Printer
Place the supply cartridge upside down on a level surface, such as a table, with
the wide side away from you.
Remove the spool caps (if used).
Pull up firmly on the full take-up spool to remove it.
Remove the end of the supply material from the empty supply spool if needed.
Dispose of the used supply according to your policy.
E
On a regular basis, such as weekly, use the cleaning pen to clean deposits
from the guides of the supply cartridge and clean the supply tracker.
Remove the empty spool from the holder and press it into place on the take-up
holder (step 1 in Figure
grooves in the holder.
Press on the spool and turn it slightly (if needed) until the spool fully covers the
ribs of the holder.
Unwrap the new supply material.
Place the full supply roll on the right holder as you face the open side of the
cartridge (step 2 in Figure
, as shown.
Take-up spool
Figure 4-9: Load supply in the cartridge
Make sure the ribs inside the spool align with the grooves in the holder. Press on
the spool and turn it slightly (if needed) until the spool fully covers the ribs.
4-9). Make sure the ribs inside the spool align with the
4-9). Make sure the supply will unroll counterclockwise
Spool caps
5
Guides
1
4
3
4-11
Supply roll
2