Load and Replace Supplies
To prepare the printer to print cards, load blank card stock into the input hopper (optional), and
load print ribbon and a cleaning sleeve onto the print cartridge. If you are using an SD460 system,
also load overlay material into the L1 and L2 (if equipped) laminator cartridges. Refer to "Load
Laminator Overlay Material" on page
Load Cards
Do the following to load cards in the printer:
1.
Open the input hopper.
2.
Load the cards into the input hopper. (Cards
can stick together. Slide or fan the cards to
separate the edges before placing them in
the input hopper.)
Insert ISO magnetic stripe cards with the
stripe (back side) facing down and to the
right.
Insert smart cards with the smart card
chip facing up and toward the back of the
hopper.
3.
Close the input hopper.
Load the Print Ribbon
Load the print ribbon when you install the printer and when
the ribbon runs out.
1.
Open the printer cover.
2.
Remove the print ribbon cartridge.
SD260L/SD360/SD460 Card Printers User's Guide
A‐8 for information about loading the laminator cartridges.
23