Prt Area - Konica Minolta Bizhub C350 Service Manual

bizhub C350 Field Service Ver. 2.0 April 2004
4.4.5

PRT Area

A. Top Margin
Functions • To vary the print start position in the FD direction for each of different paper types in
Tray1.
Use • The LPH Unit has been replaced.
• The paper type has been changed.
• The image on the copy deviates in the FD direction.
• A faint image occurs on the leading edge of the image.
Adjustment
Specification
Width A
Adjustment If width A is longer than the specifications, make the setting value smaller than the cur-
Instructions rent one.
If width A is shorter than the specifications, make the setting value greater than the cur-
rent one.
Adjustment 1. Select according to the paper used on the Paper Type Setting Dial.
2. Touch "Machine Adjust" → "PRT Area" → "Top Margin."
Procedure
3. Press the Start key to let the machine produce a test pattern.
4. Check the dimension of width A on the test pattern.
5. If width A falls outside the specified range, change the setting using the Up/Down
key.
6. Press the Start key to let the machine produce a test pattern.
7. Check the dimension of width A on the test pattern.
8. If width A is outside the specified range, change the setting again and make a check
again.
9. If width A falls within the specified range, touch "END"
10.Following the same procedure, adjust for thickpaper, OHP, and envelopes.
Width A on the test pattern produced should
fall within the following range.
Specifications : 5.0 ± 0.5 mm
Setting Range: -3.0 mm to +3.0 mm
(in 0.2 mm increments)
4036fs3009c0
3-45
TECH. REP. MODE