bizhub C350 Field Service Ver.1.0 Mar. 2004
[1]
[3]
13. Perform another test print and check the reference deviation.
A
4348fs3509c0
[2]
4348fs3510c0
[4]
4348fs3511c0
4348fs3512c0
4348fs3513c0
3-5
Mechanical adjustment
7. Measure the width of printed refer-
ence line A.
Specification: 3.0 mm
8. If the measured width A falls outside
the specified range, enter the correc-
tion value.
9. Produce another test print and check
to see if width A falls within the spec-
ified range.
• If adjustment cannot be completed
only by inputting numeric value,
perform adjustment according to
the following procedure.
10. Press the Drawer Release button [1]
and then slide out the drawer [2]
from the Paper Feed Cabinet.
11. Open the Right Door.
12. Loosen the adjustment screw [3] and
turn screw D [4] to make the adjust-
ment.
NOTE
• Do not damage the passage surface
of the Right Door.
• If width A is greater than the specified
value
Turn screw D counterclockwise.
• If width A is smaller than the specified
value
Turn screw D clockwise.
±
1.0 mm