Konica Minolta Bizhub C350 Service Manual page 267

bizhub C350 Field Service Ver. 2.0 April 2004
Code Item
C13D5 Cyan LPH correction data down-
load failure
C13D6 Magenta LPH correction data
download failure
C13D7 Yellow LPH correction data down-
load failure
C13D8 Black LPH correction data down-
load failure
C1800 Controller start failure
C3310 CCD clamp/gain adjustment failure • The adjustment value is 0 or 255 during a CCD clamp
C3331 MSC undefined malfunction occur-
ring
C3332 Scanner Section undefined mal-
function
C3333 Engine Section undefined malfunc-
tion
C3E00 NVRAM initialization failure
C3E01
C3E02
C3F00 Vendor connection failure
C3FFC ROM contents error upon startup
(LPH)
C3FFD ROM contents error upon startup
(Scanner)
C3FFE ROM contents error upon startup
(PRT)
C3FFF ROM contents error upon startup
(MSC)
Description
• . An error is detected while the LPH correction data is
being downloaded from EEPROM of LPH to PWB-
MFP when the Power Switch is turned ON.
• A controller start failure is detected in the controller
interface.
adjustment.
• The peak value of the output data is 64 or less during
a CCD gain adjustment.
• An undefined malfunction occurs in the MSC of the
MFP Control Board (PWB-MFP).
• An undefined malfunction occurs in the Scanner Sec-
tion.
• An undefined malfunction occurs in the Engine Sec-
tion (PWB-MC, etc.).
• Total Clear is executed in a mode other than the card
line mode.
• An initial command is issued from the terminal in a
mode other than the card line mode.
• A new NVRAM is detected in a mode other than the
card line mode.
• It is detected that communications with the vendor are
interrupted for a given period of time or more with
"Installed" selected for the setting of vendor installa-
tion.
• A fault is detected in a sequence of ROM contents
check of the LPH Board during starting.
• A fault is detected in a sequence of ROM contents
check of the PWB-C during starting.
• A fault is detected in a sequence of ROM contents
check of the Control Board during starting.
• A fault is detected in a sequence of ROM contents
check of the MSC (PWB-MFP) during starting
4-25
Malfunction code