Adjustment Of The Folding Positions - Konica Minolta Bizhub C350 Service Manual

bizhub C350 Field Service Ver.1.0 Mar. 2004
4.1.1

Adjustment of the folding positions

• When a folding position is adjusted, adjust the folding position to the stapling position.
Make this adjustment after replacing the Finisher Control Board or when the folding posi-
tion must be changed for some reason.
NOTE
• Depending on the type of paper, both the folding position and the stapling position
may be inaccurate. In this case, make adjustment independently from the Finisher.
In this independent adjustment from the Finisher, set the adjustment value of
"Center Stapling Position" and "Folding Position" in the service mode to ± 0 mm
on the main unit.
ON
1 2 3 4 5
- direction - direction
3. After setting the adjustment value of the folding position, set all bits of SW1 on the Fin-
isher Control Board to OFF.
4. Perform the "Booklet Creation" on the main unit, and confirm that the folding position
has been correctly adjusted. If not, redo the adjustment.
6 7 8
4583fs3510c0
+ direction + direction
4583fs3523e0
3-11
1. Set SW1 on the Finisher Control
Board as shown on the Left figure.
2. Press PSW1 or PSW2 on the Fin-
isher Control Board for the required
times to adjust the folding position.
One pressing of the switch moves
the folding position by approx. 0.16
mm.
• Press PSW1 to move the folding posi-
tion in the "-" direction.
• Press PSW2 to move the folding posi-
tion in the "+" direction.
• Press PSW1 and PSW2 simulta-
neously to clear the present set adjust-
ment value.
Board switch