Finisher Tray - Konica Minolta Bizhub C350 Service Manual

bizhub C350 Field Service Ver.1.0 Mar. 2004
1.3.13

Finisher Tray

[1]
[1]
[2]
[6]
[4]
[8]
[7]
[5]
[6]
[7]
4583fs2516c0
[2]
[2]
[2]
4583fs2546c0
[5]
[4]
[3]
4583fs2522c0
[9]
4583fs2523c0
2-11
NOTE
• The mark on the Saddle Cam Drive
Gear [5] (either of the two marks)
comes face to face with the mark on
the Middle Gear [6] (the mark on the
semispherical part with narrow gear
face width).
5. With the Saddle Cam Drive Gear [5]
and the Middle Gear [6] positioned
as above, the mark on the Middle
Gear [6] (the mark on the other semi-
spherical part) meets face to face
with the rib of the Folding Roller
Drive Gear [7].
1. Remove the Finisher Tray Upper
Cover.
☞ 2-4
2. Remove the Side Guide.
☞ 2-5
3. Remove two screws [1],and unplug
six connectors [2].
4. Pull out the Finisher Stopper Base
[3], and disengage the front claw [5]
and the rear claw [6] of the Finisher
Stopper [4].
5. Remove the Motor Harness [8] from
two Harness Saddles [7].
6. Unplug three connectors [9].
Other