Konica Minolta Bizhub C350 Service Manual page 112

Other
[17]
[18]
[19]
[21]
[22]
[23]
[25]
bizhub C350 Field Service Ver. 2.0 April 2004
[16]
4036fs2584c0
[20]
4036fs2565c0
[26]
[24]
4036fs2566c0
A
B
C
[28]
[27]
4036fs2567c0
2-74
NOTE
• Mount the Screw [16] in the direc-
tion that is opposite against the
direction for which Scanner Drive
Gear [17] and Screw [18] are
screwed together as shown in the
left figure.
12. Mount the Scanner Motor Assy.
☞ 2-66
<Front>
13. Wind the bead end of the cable [19]
around pulley C [20] and pulley B
[21], then hook the bead [22] onto
the Adjustable Anchor [23].
14. Wind the hook end of the cable [24]
around pulley A [25] and pulley B
[26].
15. Fit the hook end of the cable [27] to
the spring [28] and then hook the
spring to the catch A in the frame.
16. Measure the Spring length, and
check if its length is within the range
of 63.0 mm ± 1 mm.
<When out of the given range>
• In case of 64.1 mm or more:
Retry to put the spring on the catch B.
• In case of 61.9 mm or less:
Retry to put the spring on the catch C.