Fls Paper; Book Erase (Center); Peripheral Setting - Konica Minolta Bizhub C350 Service Manual

bizhub C350 Field Service Ver. 2.0 April 2004
4.8.5

FLS Paper

Functions • To set the size for FLS paper.
Use • Upon setup.
Setting/Procedure • Select the size from among the following four.
4.8.6

Book Erase (Center)

Functions • To change the center erase width in Book copying.
Use • As required by the user.
Setting/Procedure • The default setting is 15 mm.
4.8.7

Peripheral Setting

Functions • To set the type of the controller.
• "Peripheral Mode" appears when "Controller 2" or "Others" is selected.
• "Server Set (RD)" or "Server Set (KRDS)" appears when "Controller 3" is
selected.
Use • When setting up the controller
Setting/Procedure Peripheral Setting
• Select the controller to be used.
☞
See the Setup Instructions for the Controller.
Peripheral Mode
• Select the operating mode of the Scanner.
KRDS / RD Mode
• Use for the Remote Diagnosis System setting when the standard controller is
used.
• Settings are changed for KRDS or RD according to the Remote Diagnosis Sys-
tem selected in the Security mode.
F: 330.2 mm F: 330 mm
C: 203.2 mm C: 210 mm
15 mm (2 to 30 mm)
Without Controller : No external controllers are used.
Controller 1 : An external controller is used.
Controller 2 : An external controller is used.
Controller 3 : The standard controller is used.
Others : A controller other than above is used.
Mode 1: Fiery.
Mode 2: Not use
Mode 3: Not use
3-69
TECH. REP. MODE
F: 330.2 mm F: 330 mm
C: 215.9 mm C: 220 mm