Paper Exit / Turnover Section Misfeed - Konica Minolta Bizhub C350 Service Manual

Jam Display
1.4.3

Paper Exit / Turnover section misfeed

A. Detection timing
Type
Misfeed due to
paper remaining at Misfeed is detected if the Turnover Sensor (PC5-DF) is not turned OFF within a
the Turnover Sen- preset time after the Turnover Sensor (PC5-DF) was tuned ON.
sor
Misfeed due to
paper not reached Misfeed is detected if the Exit Sensor (PC6-DF) is not turned ON within a preset
the Exit Sensor (in time after the Turnover Sensor (PC5-DF) was turned ON in the 2-Sided mode.
the 2-Sided Mode)
Misfeed due to
Misfeed is detected if the Exit Sensor (PC6-DF) is not turned OFF within a preset
paper remaining at
time after the Exit Sensor (PC6-DF) was tuned ON.
the Exit Sensor
B. Action
Turnover Sensor (PC5-DF)
Exit Sensor (PC6-DF)
Exit Motor (M3-DF)
Step
1 Initial check items
2 PC5-DF I/O, sensor check
3 PC6-DF I/O, sensor check
4 M3-DF operation check
5 PWB-A DF replacement
Relevant electrical parts
Action
4-4
bizhub C350 Field Service Ver.1.0 Mar. 2004
Description
Control Board (PWB-A DF)
WIRING DIAGRAM
Control signal
-
PWB-A DF CN9A DF-3
PWB-A DF CN9A DF-6
-
-
Location
(Electrical compo-
nents)
-
G-2
H-2
B-7
E-5