Extended Function Mode - Omron MX2 Series User Manual

4 Parameter List
4-3

Extended Function Mode

In the extended function mode, inverter parameters are categorized in six groups: A, b, C, H, P, and U.
This section provides the parameter list for each group.
Note that the parameters displayed on the Digital Operator vary with the setting in the Display Selection
(b037). To display all parameters, set this parameter to 00 (Complete display).
The Monitor or data range column of the parameter list shows the range of parameters you can monitor
or set on the Digital Operator (4-digit LED display) of the inverter. For the actual internal data range for
this inverter, refer to 8-9 Modbus Communication Data Lists on page 8-37.
To monitor or set detailed parameter data over the upper 4 digits, please use the Inverter/Servo support
tool CX-Drive.
Precautions for Correct Use
• You can change the parameter display on the Digital Operator by the Display Selection
(b037). For details, refer to 5-1-1 Display Selection on page 5-3.
• In the 3G3MX2-V1 Series, the default data for the Display Selection (b037) was changed
from the previous default 04 (Basic display) to 00 (Complete display). You can see and set all
parameters when you turn on the power supply for the first time.
Additional Information
• You can set the initial screen displayed after turning on the power supply by the Initial Screen
Selection (b038). For details, refer to 7-6-5 Initial Screen Selection (Initial Screen after
Power-on) on page 7-56.
• You can display only the parameters registered as user parameters. It is also possible to
automatically register changed parameters, or directly set specific parameters. For details,
refer to 7-6-11 User Parameter Automatic Setting Function on page 7-60.
4 - 6
Multi-function Compact Inverter 3G3MX2-V1 User's Manual (I585-E1)