Omron MX2 Series User Manual page 131

Display Status Checks
If no problem is found at power-on, the display status will be as follows.
Name
POWER LED
ALARM LED
RUN LED
RUN command LED indicator
Data display LED (Hz)
Data display
If any problem is found, the display status will be as follows.
Refer to Section 10 Troubleshooting for countermeasures.
Name
POWER LED
ALARM LED
RUN LED
RUN command LED indicator
Data display LED (Hz)
Data display
Parameter Initialization
You can initialize the changed parameters and also clear the fault monitor data.
As a measure to prevent inadvertent parameter initialization, the inverter is designed to force the user
to set several parameters to execute initialization.
The following figure shows the steps of complete parameter initialization.
To initialize all the parameters, set the Initialization Target Setting (b094) to 00 (All data).
To initialize the fault monitor and DriveProgramming data in addition to the parameter data, set the Ini-
tialization Selection (b084) to 04.
Set the Initialization Execution (b180) to 01 (Execute initialization) to execute parameter initialization.
For details on parameter initialization, refer to 5-1 Parameter Display and Parameter Initialization on
page 5-3.
Step 1: Press the Enter key
to set b084 to "04".
Multi-function Compact Inverter 3G3MX2-V1 User's Manual (I585-E1)
Display status
Lit
Not lit
Not lit (Lit during RUN)
Lit
Lit
Displays d001 setting.
Display status
Lit
Lit
Not lit
Lit
Lit
Displays alarm code such as E01 on data display.
(Displayed alarm code differ depending on error condition.)
Step 2: Press the Enter key
to set b180 to "01".
3 Operation and Test Run
Step 3: Initialization is com-
pleted when the ini-
tialization display
disappears
Initializing
Initialization
completed
3
3 - 23