Omron MX2 Series User Manual page 525

Name
Encoder The inverter trips, when the output fre-
disconnection quency is at the Creep Speed Setting
(P015) or higher, if the motor rotation
speed detected by the encoder
remains lower than the Starting Fre-
quency (b082) for the duration set in
the Encoder Disconnection Detection
Time (P077 ≠ 0) or longer.
Overspeed The inverter trips if the motor rotation
speed exceeds the value set in Maxi-
mum Frequency × Overspeed Error
Detection Level (P026 ≠ 0).
Position The inverter trips if the current posi-
control range tion is out of the range set in the Posi-
trip tion Limit Setting (P072, P073) during
simple position control.
Multi-function Compact Inverter 3G3MX2-V1 User's Manual (I585-E1)
Description
E80.
E81.
E83.
10 Troubleshooting
Alarm
Check and remedy
code
The encoder wiring is discon-
nected or connected improperly.
• Check the encoder wiring.
The actual motor rotation speed
remains lower than the Starting
Frequency (b082) for the duration
set in the Encoder Disconnection
Detection Time (P077) or longer.
• Adjust the parameter values.
Set a slightly longer time in
P077 and a slightly higher
value in P015.
This alarm also occurs if the
motor rotation speed drops to
lower than the Starting Frequency
under simple position control.
• Adjust the parameter values.
Set a slightly longer time in
P077 and a slightly higher
value in P015.
This alarm is displayed based on
the speed detected by the
encoder.
The encoder wiring is discon-
nected or connected improperly.
• Check the encoder wiring.
The Number of Encoder Pulses
does not match.
• Check the number of
encoder pulses. (P011)
The actual motor speed is higher
than the error detection level.
• Adjust the Overspeed Error
Detection Level (P026) set-
ting.
Check the current position.
• Check the parameter settings
(P072, P073).
• Check the origin.
Reference
page
10
P. 6-18
P. 6-28
P. 6-18
P. 6-28
P. 6-34
10 - 9