NETGEAR ProSafe SRX5308 Cli Reference Manual page 51

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Note: To be able to configure an ISATAP tunnel, you first need to set the IP
mode to IPv4/IPv6 (see
Step 1 Format
net ipv6_tunnel isatap add
Mode net
Step 2 Format
subnet_prefix <subnet prefix>
end_point_type {LAN | Other_IP {ipv4_address <address>}}
Mode net-config [isatap-tunnel]
Keyword Associated Keyword to
Select or Parameter to Type
subnet_prefix subnet prefix
end_point_type LAN or Other_IP
ipv4_address ipaddress
Command example:
SRX5308> net ipv6_tunnel isatap add
net-config[isatap-tunnel]> subnet_prefix 2004::
net-config[isatap-tunnel]> end_point_type Other_IP
net-config[isatap-tunnel]> ipv4_address 10.29.33.4
net-config[isatap-tunnel]> save
Related show commands:
net ipv6_tunnel isatap edit <row id>
This command configures an existing ISATAP tunnel. After you have issued the net
ipv6_tunnel isatap edit command to specify the row to be edited, you enter the
net-config [isatap-tunnel] mode, and then you can change the subnet prefix only.
Step 1 Format
net ipv6_tunnel isatap edit <row id>
Mode net
net ipv6 ipmode
Description
The IPv6 64-bit subnet prefix (string) that is assigned to
the logical ISATAP subnet for this intranet.
Specifies the local endpoint IP address for the tunnel that
is initiated on the VPN firewall. The endpoint can be the
LAN interface or a specific LAN IPv4 address. If you select
Other_IP, you also need to issue the ipv4_address
keyword to specify an IPv4 address.
The IPv4 address of a local endpoint that is not a LAN IPv4
address.
show net ipv6_tunnel setup
Net Mode Configuration Commands
51
configure).
and show net ipv6_tunnel status