NETGEAR ProSafe SRX5308 Cli Reference Manual page 126

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Keyword (might consist of two
separate words)
service_name
custom_services
action
schedule
LAN server addresses, port number translation, and WAN destination addresses
send_to_lan_server
send_to_lan_server_start_ip
send_to_lan_server_end_ip
translate_to_port_number
enable
translate_to_port_number
port
wan_destination_ip_address
wan_destination_ip_address_start
Associated Keyword to Select or
Parameter to Type
custom service name
ALWAYS_BLOCK, ALWAYS_ALLOW,
BLOCK_BY_SCHEDULE_ELSE_ALLOW,
or ALLOW_BY_SCHEDULE_ELSE_BLOCK
Schedule1, Schedule2, or
Schedule3
ANY, SINGLE_ADDRESS, or
ADDRESS_RANGE
ipaddress
ipaddress
Y or N
number
WAN1, WAN2, WAN3, WAN4, or RANGE Specifies the type of destination
ipaddress
Security Mode Configuration Commands
126
Description
The custom service that you have
configured with the security
services add command and to
which the firewall rule applies.
Specifies the type of action to be
enforced by the rule.
Specifies the schedule, if any, that
is applicable to the rule.
Specifies the type of LAN address.
There are two options:
• The IP address if the
send_to_lan_server
keyword is to SINGLE_ADDRESS.
• The start IP address if the
send_to_lan_server
keyword is set to
ADDRESS_RANGE.
The end IP address if the
send_to_lan_server keyword
is set to ADDRESS_RANGE.
Enables or disables port
forwarding.
The port number (integer) if port
forwarding is enabled. Valid
numbers are 0 through 65535.
WAN address for an inbound rule:
• WAN1, WAN2, WAN3, or WAN4.
The IP address of the selected
WAN interface.
• RANGE. A range of public IP
addresses, which you need to
configure by issuing the
wan_destination_ip_address_start
and
wan_destination_ip_address_end
keywords and specifying IPv4
addresses.
The start IP address if the
wan_destination_ip_address
keyword is set to RANGE.