NETGEAR ProSafe SRX5308 Cli Reference Manual page 94

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Keyword
interface
gateway_address
metric
Command example:
SRX5308> net routing static ipv4 configure Orly
net-config[static-routing-ipv4]> active_flag Y
net-config[static-routing-ipv4]> private_flag Y
net-config[static-routing-ipv4]> destination_address 10.118.215.178
net-config[static-routing-ipv4]> subnet_mask 255.255.255.0
net-config[static-routing-ipv4]> interface wan WAN1
net-config[static-routing-ipv4]> gateway_address 10.192.44.13
net-config[static-routing-ipv4]> metric 7
net-config[static-routing-ipv4]> save
Related show command:
net routing static ipv4 delete <route name>
This command deletes a static IPv4 route by deleting its name.
Format
net routing static ipv4 delete <route name>
Mode net
Related show command:
Associated Keyword to Select
or Parameter to Type
custom_vlan <VLAN name>,
dmz, lan, or wan {WAN1,
WAN2, WAN3, WAN4}
ipaddress
number
show net routing static ipv4 setup
show net routing static ipv4 setup
Net Mode Configuration Commands
94
Description
Specifies the interface for which the route is
applied. The dmz and lan keywords do not
require additional selections. The custom vlan
and wan keywords require additional selections:
• If you issue the custom_vlan keyword, you
also need to specify the VLAN name.
• If you issue the wan keyword, you also need to
specify the WAN interface (WAN1, WAN2,
WAN3, or WAN4).
The gateway IP address.
The metric (integer) for this route. The number
can be from 2 to 15.