NETGEAR ProSafe SRX5308 Cli Reference Manual page 37

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Related show commands:
ipv4 status <wan interface>
net wan wan ipv4 secondary_address add <wan interface>
This command configures a secondary IPv4 WAN address. After you have issued the net
wan wan ipv4 secondary_address add command to specify one of the four WAN
interfaces (that is, WAN1, WAN2, WAN3, or WAN4), you enter the
net-config [wan-secondary-address] mode, and then you can configure the secondary WAN
address and subnet mask in the order that you prefer.
Step 1 Format
net lan ipv4 multi_homing add {WAN1 | WAN2 | WAN3 | WAN4}
Mode net
Step 2 Format
ip_address <ipaddress>
subnet_mask <subnet mask>
Mode net-config [wan-secondary-address]
Keyword Associated
Parameter to Type
ip_address ipaddress
subnet_mask subnet mask
Command example:
SRX5308> net wan wan ipv4 secondary_address add WAN2
net-config[wan-secondary-address]> ip_address 10.168.50.1
net-config[wan-secondary-address]> subnet_mask 255.255.255.0
net-config[wan-secondary-address]> save
Related show commands:
net wan wan ipv4 secondary_address delete <row id>
This command deletes a secondary IPv4 WAN address by deleting its row ID.
Format
net wan wan ipv4 secondary_address delete <row id>
Mode net
Related show commands:
show net wan wan ipv4 setup <wan interface>
Description
The secondary IPv4 address for the selected WAN interface.
The subnet mask for the secondary IP address.
show net wan wan ipv4 secondary_addresses <wan interface>
show net wan wan ipv4 secondary_addresses <wan interface>
Net Mode Configuration Commands
37
and show net wan wan