NETGEAR ProSafe SRX5308 Cli Reference Manual page 81

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
net qos profile add
This command configures a new WAN QoS profile. After you have issued the net qos
profile add command, you enter the net-config [network-qos-profile] mode, and then you
can configure one keyword and associated parameter or associated keyword at a time in the
order that you prefer.
Step 1 Format
net qos profile add
Mode net
Step 2 Format The following settings apply to both rate control profiles and priority profiles:
qos_type {Rate-Control | Priority}
interface {WAN1 | WAN2 | WAN3 | WAN4}
service_name {default_services <default service name> |
diffserv_qos_match <number>
diffserv_qos_remark <number>
The following settings apply only to rate control profiles:
direction_for_rate_control {Inbound | Outbound | Both}
congestion_priority {Default | High | Medium-high | Medium | Low}
hosts {Single-IP-Address {hosts_start_ip <ipaddress>} |
Group4 | Group5 | Group6 | Group7 | Group8}}}
bandwidth_allocation {Shared | Individual}
outbound_min_bandwidth <bandwidth>
outbound_max_bandwidth <bandwidth>
inbound_min_bandwidth <bandwidth>
inbound_max_bandwidth <bandwidth>
The following settings apply only to priority profiles:
direction_for_priority {Inbound-Traffic | Outbound-Traffic}
priority {Low | High}
Mode net-config [network-qos-profile]
{custom_services <custom service name>}
IP-Address-Range {hosts_start_ip <ipaddress>} {hosts_end_ip
<ipaddress>} | Group {hosts_group {Group1 | Group2 | Group3 |
Net Mode Configuration Commands
81