Wan Qos Commands - NETGEAR ProSafe SRX5308 Cli Reference Manual

Command example:
SRX5308> net radvd configure dmz
net-config[radvd-dmz]> enable Y
net-config[radvd-dmz]> mode Unicast-Only
net-config[radvd-dmz]> flags Managed
net-config[radvd-dmz]> preference High
net-config[radvd-dmz]> mtu 1500
net-config[radvd-dmz]> life_time 7200
net-config[radvd-dmz]> save
Related show command:

WAN QoS Commands

net qos configure
This command configures the QoS mode for the WAN interfaces. After you have issued the
net qos configure command, you enter the net-config [network-qos] mode, and then you
can enable QoS and set the QoS mode to rate control or priority.
The configured QoS mode determines which WAN QoS profiles can be active, that is, you
can add both rate control or priority WAN QoS profiles (see the
command), but only the profiles for the configured QoS mode can be active. For example, if
you set the QoS mode to priority, then only the profiles with a priority configuration can be
active.
Step 1 Format
Mode
Step 2 Format
Mode
Keyword
enable
qos_type
Related show command:
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
show net radvd dmz setup
net qos configure
net
enable {Y | N}
qos_type {Rate-Control | Priority}
net-config [network-qos]
Associated Description
Keyword to Select
Y or N Enables or disables QoS for all WAN interfaces.
Rate-Control or Specifies whether QoS uses rate control or priority profiles.
Priority
show net qos setup
Net Mode Configuration Commands
net qos profile add
80