Ipsec Vpn Policy Commands - NETGEAR ProSafe SRX5308 Cli Reference Manual

Command example:
SRX5308> vpn ipsec ikepolicy configure SRX-to-Paris
vpn-config[ike-policy]> enable_mode_config N
vpn-config[ike-policy]> direction_type Both
vpn-config[ike-policy]> exchange_mode Main
vpn-config[ike-policy]> ip_version ipv4
vpn-config[ike-policy]> select_local_gateway WAN1
vpn-config[ike-policy]> local_ident_type Local_Wan_IP
vpn-config[ike-policy]> local_identifier 10.139.54.228
vpn-config[ike-policy]> remote_ident_type Remote_Wan_IP
vpn-config[ike-policy]> remote_identifier 10.112.71.154
vpn-config[ike-policy]> encryption_algorithm 3DES
vpn-config[ike-policy]> auth_algorithm SHA-1
vpn-config[ike-policy]> auth_method Pre_shared_key
vpn-config[ike-policy]> pre_shared_key 3Tg67!JXL0Oo?
vpn-config[ike-policy]> dh_group Group2_1024_bit
vpn-config[ike-policy]> lifetime 28800
vpn-config[ike-policy]> enable_dead_peer_detection Y
vpn-config[ike-policy]> detection_period 20
vpn-config[ike-policy]> reconnect_failure_count 3
vpn-config[ike-policy]> extended_authentication EdgeDevice
vpn-config[ike-policy]> extended_authentication_type RadiusChap
vpn-config[ike-policy]> save
Related show command:
vpn ipsec ikepolicy delete <ike policy name>
This command deletes an IKE policy by specifying the name of the IKE policy.
Format
vpn ipsec ikepolicy delete <ike policy name>
Mode vpn
Related show command:

IPSec VPN Policy Commands

vpn ipsec vpnpolicy configure <vpn policy name>
This command configures a new or existing auto IPSec VPN policy or manual IPSec VPN
policy. After you have issued the vpn ipsec vpnpolicy configure command to specify the
name of a new or existing VPN policy, you enter the vpn-config [vpn-policy] mode, and then
you can configure one keyword and associated parameter or associated keyword or
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
show vpn ipsec ikepolicy setup
show vpn ipsec ikepolicy setup
VPN Mode Configuration Commands
216