NETGEAR ProSafe SRX5308 Cli Reference Manual page 189

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Step 1 Format
system remote_management telnet configure
Mode system
Step 2 Format
ip_version {IPv4 | IPv6}
enable_ipv4 {Y | N}
access_type {Everyone | IP_Range {from_address <ipaddress>}
enable_ipv6 {Y | N}
access_type6 {Everyone | IP_Range {from_address6
Mode system-config [telnet]
Keyword Associated Keyword to
Select or Parameter to Type
IPv4 or IPv6
ip_version
Telnet over an IPv4 connection
Y or N
enable_ipv4
Everyone, IP_Range, or
access_type
To_this_PC_only
from_address ipaddress
to_address ipaddress
only_this_pc_ip ipaddress
Telnet over an IPv6 connection
Y or N
enable_ipv6
{to_address <ipaddress>} | To_this_PC_only {only_this_pc_ip
<ipaddress>}}
<ipv6-address>} {to_address6 <ipv6-address>} |
To_this_PC_only {only_this_pc_ip6 <ipv6-address>}}
System Mode Configuration Commands
189
Description
Specifies the configuration of IPv4 or IPv6.
Enables or disables remote management over Telnet
for an IPv4 connection.
Specifies the type of access:
• Everyone. Enables access to all IP addresses. You
do not need to configure any IP address.
• IP_Range. Enables access to a range of IP
addresses. You also need to configure the
from_address and to_address keywords and
associated parameters.
• To_this_PC_only. Enables access to a single IP
address. You also need to configure the
only_this_pc_ip keyword and associated
parameter.
The start IP address if you have set the
access_type keyword to IP_Range.
The end IP address if you have set the access_type
keyword to IP_Range.
The single IP address if you have set the
access_type keyword to To_this_PC_only.
Enables or disables remote management over Telnet
for an IPv6 connection.