NETGEAR ProSafe SRX5308 Cli Reference Manual page 115

ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Keyword (might consist of two
separate words)
log
bandwidth_profile
nat_ip type
nat_ip address
Command example:
SRX5308> security firewall ipv4 add_rule lan_wan outbound
security-config[firewall-ipv4-lan-wan-outbound]> service_name default_services HTTP
security-config[firewall-ipv4-lan-wan-outbound]> action
security-config[firewall-ipv4-lan-wan-outbound]> lan_users group_wise SalesAmericas
security-config[firewall-ipv4-lan-wan-outbound]> wan_users address_wise ANY
security-config[firewall-ipv4-lan-wan-outbound]> bandwidth profile PriorityQueue
security-config[firewall-ipv4-lan-wan-outbound]> nat_ip type Auto
security-config[firewall-ipv4-lan-wan-outbound]> log NEVER
security-config[firewall-ipv4-lan-wan-outbound]> save
Related show command:
Associated Keyword to Select or
Parameter to Type
NEVER or ALWAYS
profile name
Auto, WAN1, WAN2, WAN3, or
WAN4
ipaddress
show security firewall ipv4 setup lan_wan
Security Mode Configuration Commands
115
Description
Specifies whether logging is
disabled or enabled.
The name of the bandwidth profile
that you have specified with the
security bandwidth profile add
command.
Specifies the type of NAT IP
address for a nonblocking rule:
• Auto. The source address of the
outgoing packets is autodetected
through the configured routing
and load balancing rules.
• WAN1, WAN2, WAN3, or WAN4.
The IP address of the selected
WAN interface.
Note: The nat_ip type and
nat_ip address keywords are
mutually exclusive.
The NAT IP address, if the address
is different from the IP address of a
WAN interface, for example, a
secondary WAN IP address.
Note: The nat_ip type and
nat_ip address keywords are
mutually exclusive.
ALWAYS_ALLOW