The Four Main Modes For Configuration Commands - NETGEAR ProSafe SRX5308 Cli Reference Manual

The Four Main Modes for Configuration Commands

For the configuration commands, there are four main modes in the CLI: net, security, system,
and vpn. Chapter 2, Overview of the Configuration Commands
modes, and each of these modes is described in detail in a separate chapter (see
through Chapter 6).
The following table lists the main configuration modes, the configuration modes, the features
that you can configure in each configuration mode, and, for orientation, the basic web
management interface (GUI) path to the feature.
Table 3. Main configuration modes
__________________________CLI________________________ ___Web Management Interface (GUI)___
Main Mode Submode
Network configuration commands
net ddns
dmz
ethernet
ipv6
ipv6_tunnel
lan
protocol_binding Protocol bindings
qos
radvd
routing
ProSafe Gigabit Quad WAN SSL VPN Firewall SRX5308
Feature That You Can Configure Basic Path
Dynamic DNS
DMZ for IPv4
DMZ for IPv6
VLAN assignment to LAN interface Network Configuration > LAN Setup
IPv4 or IPv4/IPv6 mode
IPv6 tunnels
IPv4 LAN settings and VLANs
LAN groups for IPv4
Secondary IPv4 LAN addresses
Advanced IPv4 LAN settings
Fixed and reserved DHCP IPv4
addresses
LAN IPv4 traffic meter profiles
IPv6 LAN settings
Secondary IPv6 LAN addresses
IPv6 LAN DHCP address pools
IPv6 prefix delegation for the LAN
WAN QoS profiles
IPv6 RADVD and pools for the
LAN
IPv6 RADVD and pools for the
DMZ
Dynamic IPv4 routes
Static IPv4 routes
Static IPv6 routes
Introduction
lists all commands in these
Network Configuration > Dynamic DNS
Network Configuration > DMZ Setup
Network Configuration > WAN Settings
Network Configuration > WAN Settings
Network Configuration > LAN Setup
Network Configuration > Protocol Binding
Network Configuration > QoS
Network Configuration > LAN Setup
Network Configuration > DMZ Setup
Network Configuration > Routing
10
Chapter 3