List Of Commands; Table 20: Cli Commands To Configure Cflowd Parameters - Alcatel-Lucent 7750 SR OS Configuration Manual

List of Commands

Table 20
each command is implemented with a short command description. The cflowd command list is
organized in the following task-oriented manner:
•
•

Table 20: CLI Commands to Configure Cflowd Parameters

Command
Configure cflowd parameters
config> router>cflowd#
active-timeout
cache-size
inactive-timeout
overflow
rate
no shutdown
Configure collection parameters
config> router>cflowd>collector#
collector
aggregation
as-matrix
destination-prefix
Page 444
lists all the cflowd configuration commands indicating the configuration level at which
Configure cflowd parameters
Configure collection parameters
Configures maximum amount of time before an active flow will be
removed from the active cache.
Specifies the maximum number of active flows to maintain in the
flow cache table.
Specifies the amount of time, in seconds, that must elapse without a
packet matching a flow in order for the flow to be considered
inactive and removed from the active cache.
Specifies the percentage of the flow cache entries removed when
the maximum number of entries is exceeded.
Specifies the rate (N) at which traffic is sampled. A packet is
sampled every N packets.
Administratively enables cflowd.
Defines a flow data collector for cflowd data using an IP address
and a port number as identifiers. A maximum of 5 collectors can be
configured.
Configures the type of aggregation scheme(s).
Specifies that the aggregation data should be based on autonomous
system (AS) information.
Specifies that the aggregation data is based on destination prefix
information.
Description
7750 SR OS Router Configuration Guide
Page
465
466
469
470
470
469
466
466
467
467