Alcatel-Lucent 7750 SR OS Configuration Manual page 94

Configuration Commands
Table 5: Default Route Preferences
enable — Static routes can be administratively enabled or disabled. Use the enable parameter to re-
disable — Static routes can be administratively enabled or disabled. Use the disable parameter to
bfd-enable — Associates the state of the static route to a BFD session between the local system and
mcast-ipv4 — Specifies peers that are IPv4 multicast capable.
Page 94
Route Type
Static-route
OSPF Internal routes
IS-IS level 1 internal
IS-IS level 2 internal
OSPF External
IS-IS level 1 external
IS-IS level 2 external
BGP
Default 5
Values
1 — 255
enable a disabled static route. In order to enable a static route, it must be uniquely identified by
the IP address, mask, and any other parameter that is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default
enable
disable a static route while maintaining the static route in the configuration. In order to enable a
static route, it must be uniquely identified by the IP address, mask, and any other parameter that
is required to identify the exact static route.
The administrative state is maintained in the configuration file.
Default
enable
the configured nexthop. This keyword cannot be configured if the nexthop is indirect or
blackhole keywords are specified.
Preference Configurable
5
10
15
18
150
160
165
170
7750 SR OS Router Configuration Guide
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes