Alcatel-Lucent 7750 SR OS Configuration Manual page 392

Description
Default
Parameters
snmp-test
Syntax
Context
Description
Default
Parameters
oid
Syntax
Context
Description
Default
Parameters
return-value
Syntax
Context
Description
Page 392
Redirect policies can contain multiple destinations. Each destination is assigned an initial or base
priority which describes its relative importance within the policy. If more than one destination is
specified, the destination with the highest effective priority value is selected.
100
priority — The priority, expressed as a decimal integer, used to weigh the destination's relative
importance within the policy.
Values 1 — 255
snmp-test test-name
config>filter>redirect-policy>destination
This command enables the context to configure SNMP test parameters.
none
test-name — specifies the name of the SNMP test. Allowed values are any string up to 32 characters
long composed of printable, 7-bit ASCII characters. If the string contains special characters (#, $,
spaces, etc.), the entire string must be enclosed within double quotes.
oid oid-string community community-string
config>filter>redirect-policy>destination>snmp-test
This command specifies the OID of the object to be fetched from the destination.
none
oid-string — Specifies the object identifier (OID) in the OID field.
community community-string — The SNMP v2 community string or the SNMP v3 context name
used to conduct this SNMP test.
return-value return-value type return-type [disable | lower-priority priority | raise-priority
priority]
config>filter>redirect-policy>destination>snmp-test
This command specifies the criterion to adjust the priority based on the test result. Multiple criteria
can be specified with the condition that they are not conflicting or overlap. If the returned value is
7750 SR OS Router Configuration Guide