Alcatel-Lucent 7750 SR OS Configuration Manual page 304

List of Commands
Table 18: CLI Commands to Configure Filter Policies Parameters (Continued)
Command
Configure an IPv6 filter policy
config>filter
ipv6-filter
default-action
description
renum
scope
Configure an IPv6 filter policy entry
config>filter>ipv6-filter
entry
action
description
log log-id
Configure an IPv6 filter entry matching criteria
config>filter>ipv6-filter>entry
match
dscp
dst-ip
dst-port
icmp-code
Page 304
Creates an IPv6 filter policy.
The default action specifies the action to be applied to packets when the
packets do not match the specified criteria in any of the IPv6 filter entries
of the filter.
A text string describing the IPv6 filter policy.
Renumbers existing filter entries to properly sequence filter entries.
Configures the IPv6 filter policy scope as exclusive or template. An
exclusive policy can only be applied to a single entity (such as a SAP or
network port). A template policy can be applied to multiple SAPs or
network ports.
Creates an IPv6 filter entry and identifies a group of match criteria and the
corresponding action.
Creates the drop or forward action associated with the match criteria. If
not specified, the filter policy entry is not taken into account.
A text string describing the entry.
Creates a context for configuring destinations for event streams to direct
events, alarms/traps and debug information to their respective
destinations.
Creates context for entering/editing match criteria for the filter entry.
Configures a DiffServ Code Point (DSCP) name to be used as an IP filter
match criterion.
Configures a destination IP address range to be used as an IP filter match
criterion.
Configures a destination TCP or UDP port number or port range for an IP
filter match criterion.
Configures matching on ICMP code field in the ICMP header of an IP
packet as an IP filter match criterion.
7750 SR OS Router Configuration Guide
Description Page
358
363
357
388
363
364
368
357
360
371
375
375
376
377