Configuring Ies Or Vprn Service Vrrp Parameters - Alcatel-Lucent 7750 SR OS Configuration Manual

Configuring IES or VPRN Service VRRP Parameters

VRRP parameters can be configured on an interface in an IES or VPRN service to provide
virtual default router support which allows traffic to be routed without relying on a single
router in case of failure.
VRRP can be configured the following ways:
Use the following CLI syntax to configure IES or VPRN service owner and non-owner VRRP
parameters:
CLI Syntax: config>service# ies service-id [customer customer-id ]
7750 SR OS Router Configuration Guide
• Non-Owner IES or VPRN VRRP Example on page 212
• Owner IES or VPRN VRRP on page 214
config>service# vprn service-id [customer customer-id ]in-
terface ip-int-name
address ip-addr/mask-length [broadcast {all-ones|host-
ones}]
no shutdown
vrrp vrid
authentication-type {password}
authentication-key [authentication-key | hash-key]
[hash|hash2]
backup ip-addr
init-delay seconds
mac ieee-mac-address
master-int-inherit
priority base-priority
policy vrrp-policy-id [context service-id]
preempt
message-interval seconds
ping-reply
telnet-reply
ssh-reply
shutdown
vrrp vrid owner
authentication-type {password}
authentication-key [authentication-key | hash-key]
[hash|hash2]
backup ip-addr
init-delay seconds
mac ieee-mac-address
message-interval seconds
VRRP
Page 211