Alcatel-Lucent 7750 SR OS Configuration Manual page 45

Table 4: CLI Commands to Configure Basic IP Router Parameters (Continued)
Command
autonomous-system
confederation
ecmp
ignore-icmp-
redirect
mc-maximum-routes
service-prefix
static-route
triggered-policy
Configure a network interface
config>router>interface
address
allow-directed-
broadcasts
arp-timeout
bfd
cflowd
local-proxy-arp
loopback
mac
ntp-broadcast
port
proxy-arp-policy
qos
remote-proxy-arp
secondary
7750 SR OS Router Configuration Guide
Assigns an autonomous system (AS) number to the router.
Creates a confederation within an AS.
Enables ECMP and configures the number of routes for path sharing.
Drops or accepts ICMP redirects received on the management interface.
Specifies the maximum number of multicast routes that can be held within
a VPN routing/forwarding (VRF) context.
Creates an IP address range reserved for IES and certain VPLS services.
The purpose of reserving IP addresses using service-prefix is to provide a
mechanism to reserve one or more address ranges for services.
Creates static route entries for both the network and access routes.
Triggers route policy re-evaluation.
Assigns an IP address, subnet and broadcast address format to an IP
interface. Only one IP address is associated with an IP interface.
Enables the forwarding of directed broadcasts out of the IP interface.
Configures the minimum time in seconds that an address resolution
protocol (ARP) entry learned on the IP interface will be stored in the ARP
table.
Specifies the bi-directional forwarding detection (BFD) parameters for the
associated IP interface
Enables the collection of traffic flow samples through a router for analysis.
Enables local proxy ARP on the interface.
Configures the interface as a loopback interface.
Assigns a specific MAC address to an IP interface.
Enables receiving of SNTP broadcasts on the IP interface.
Creates an association with an IP interface and a physical port.
Specifies an existing policy-statement to analyze match and action criteria
that controls the flow of routing information to and from a given protocol,
set of protocols, or a particular neighbor.
Associates a network Quality of Service (QoS) policy with an IP interface.
Enables remote proxy ARP on the interface.
Assigns a secondary IP address, IP subnet/broadcast address format to the
interface.
IP Router Configuration
Description Page
87
87
88
89
89
90
91
91
51
96
98
98
98
99
99
100
100
100
100
101
102
102
103
Page 45