[Handset, Headset] Cordless Accessory Registration and Deregistration Issues
If the Cordless device is registered to another Deskset or telephone, it must be deregistered first. See
Deregistering a Cordless Accessory" on page
[Handset, Headset] If a Password is Being Used
If you have set a user password (see
Password screen shown in Figure 89 displays when you begin the registration process by
pressing MENU, and then 2 to access the User Settings screen.
Enter your password and press SELECT.
To correct errors, use the
To cancel your changes on that screen, press
to the previous screen.
[Handset, Headset] Time-out Period
For security reasons, the registration process on both Deskset and cordless accessory terminates after the time-out period of two
minutes if registration is not successful.
If the registration process times out on the cordless accessory, the cordless accessory resets itself. The Deskset returns
to the unregistered cordless accessory startup screen.
The Handset displays Registration Failed if the process times out.
If the registration process times out on the Deskset, it displays Registration Failed and returns to Idle mode.
If Cordless Headset registration fails, the ON/OFF light on the Headset flashes twice every five seconds. To reset the Headset,
remove the Headset from the charger and try the registration process again, beginning with Step 1,
Cordless Headset:" on page
Settings
Synapse User's Guide
93.
"Change User Password" on page
key.
92.
97), the User
at any time. The set returns
95
"[Handset, Headset]
User Password
Enter user password:
Use dial pad to enter user password.
Press SELECT when done.
Backspc
Figure 89. Enter User Password
"To register the TL7600
Quick
Dial
Cancel