Display And Debug; Configuration Example - 3Com 3032 Configuration Manual

Display and Debug

PPP
Typical PPP
Configuration
Example
PAP Authentication
Example
CHAP Authentication
Example
Disable applying the setting of virtual Baud rate on
interface
By default, virtual Baud rate is not set on interface.
Please use the
display
Table 212 Display and debug PPP
Operation
Display Multilink PPP information
Enable the debugging of PPP
I. Configuration Requirement
As shown in Figure 50, Router1 and Router2 are interconnected through interface
Serial0, and router Router1 (authenticator) is required to authenticate router
Router2 (requester) in PAP mode.
II. Networking Diagram
Figure 50 Networking diagram of PAP and CHAP authentication example
Router 1
Quidway 1
III. Configuration Procedure
1 Configure Router1 (authenticator):
a Add a user with name Router2 and password hello to the local database
[Router]local-user Router2 password simple hello
b Configure to start PAP authentication at this side
[Router]interface serial 0
[Router-Serial0]ppp authentication-mode pap
2 Configure Router 2 (requester):
a Configure this side to be authenticated by the opposite side with username
Router2 and password hello
[Router]interface serial 0
[Router-Serial0]ppp pap local-user Router2 password simple hello
I. Configuration Requirement
In Figure 50, Router1 is required to authenticate Router2 in CHAP mode.
and commands in all views.
debugging
Command
display ppp mp [ interface type
number ]
debugging ppp { event | lqr |
negotiation | packet | all }
Display and Debug PPP
undo virtualbaudrate
Router 2
Quidway 2
175