3Com 3032 Configuration Manual page 195

When a router originates a call to PBX, it usually contains all called number
information in the SETUP message. However, you can configure the command
to determine whether the Sending Sending-Complete Information Element
(SCIE) should be carried in the SETUP message.
Perform the following configurations in interface view.
Table 223 Configure the sending mode
Operation
Enable the router to carry the Sending-Complete
Information Element (SCIE) in the SETUP message
when sending a number
Disable the router to carry the Sending-Complete
Information Element in the SETUP message when
sending the number
By default, when a router sends a number, the Sending-Complete Information
Element is carried in the SETUP message.
d Interval of QSIG signaling timer
Perform the following configurations in interface view.
Table 224 Configure interval for QSIG signaling timer
Operation
Set interval for a QSIG signaling timer
Restore the default interval value(s) of QSIG
signaling timer(s)
You can configure the QSIG signaling timers, including T301, T302, T303,
T304, T305, T308, T309, T310, T313, T316 and T322. Also, you can use the
display isdn qsig-timer
QSIG signaling timers.
3 Verify the called number in an ISDN incoming call
Whenever an ISDN called party receives an incoming call, it can verify the called
number in the incoming call from the remote end. If the called number in the
remote call differs from the local configuration, the call will be denied. Otherwise,
the call will be accepted.
Perform the following configurations in interface view.
Table 225 Set the called number or sub-address to be checked in digital incoming call
Operation
Set the called number or sub-address to be
checked in digital incoming call
Remove the called number or sub-address to
be checked in digital incoming call
By default, no called number or sub-address is configured.
The commands are used to set the items to be checked in the digital incoming call.
If the sub-address is set, call of the opposite will be rejected when the sub-address
is not sent or is sent incorrectly.
Command
isdn sending-complete
undo isdn sending-complete
Command
isdn qsig-timer timer-name
time-interval
undo isdn qsig-timer {
timer-name | all }
command to view the default values of all the
Command
isdn check-called-number [
called-party ] [ :sub-address
]
undo isdn check-called-number
Configure ISDN 191