3Com 3032 Configuration Manual page 94

90 C 6: D
HAPTER ISPLAY AND
D T
EBUGGING OOLS
Set the direction of syslog outputting log information
As described before, Syslog of the 3Com Router 1.x can output various log
information in four directions:
Output log information to local control console via Console port
Output log information to remote Telnet terminal or dumb terminal. This
function is helpful to remote maintenance.
Allocate proper router buffer to record log information.
By configuring the log host, log information is directly sent by Syslog to the log
host and then saved as file for later view.
Please enter the following commands in system view.
Figure 38 Set the direction of syslog output log information
Operation
Enable to output log information to local control
console
Disable to output log information to local control
console
Enable to output log information to the terminal info-center monitor
Disable to output log information to the terminal undo info-center monitor
Enable to output log information to internal
buffer
Disable to output log information to internal
buffer
Define the size of internal buffer of output log
information
Enable to output log information to the log host info-center loghost
Disable to output log information to the log host undo info-center loghost
Change the language mode (Chinese | English) of
output log information
Here, Console and Monitor stand for default output directions.
The setting of output direction of the log information will be effective only if
Syslog is turned on.
The settings of the output log information in four directions are independent. The
shutdown of an output in any direction will not affect the output in other
directions.
When there are multiple telnet users or dumb terminal users simultaneously,
various users share the same configuration parameters, which include the filtering
setting based on the module, Chinese/English selection and severity threshold.
When a user changes the values of these parameters, other user terminals will also
be affected. At this time, the
off the log information output on the respective terminal. Therefore, to turn off
the log information outputs of all telnet terminals and dumb terminals, please use
the
undo info-center monitor all
Command
info-center console
undo info-center console
info-center logbuffer
undo info-center logbuffer
info-center logbuffer size
info-center { console | monitor
| logbuffer | loghost} {
chinese | english }
undo info-center monitor
command.
command can only turn