3Com 3032 Configuration Manual page 186

182 C 13: C
HAPTER ONFIGURING
Display and Debug
PPPoE Client
Typical PPPoE
Configuration
Example
Access a LAN to the
Internet via ADSL
PPP E C
O LIENT
Regardless of whether a PPPoE session is permanent or packet-triggered,
executing the
undo pppoe-client
Hence, you need to make reconfiguration for establishing a new PPPoE session.
Perform the
display
Table 216 Display and debug PPPoE Client
Operation
Display state of the PPPoE session and the
statistic information as well
Enable debugging of PPPoE client
I. Networking Requirements
The PCs on a LAN access the Internet via RouterA, and RouterA adopts the
permanent approach to accesses the Internet via ADSL. It uses "3com" as the user
name of the ADSL account, and the password is 12345. Enable the PPPoE client
function on the router, so that the hosts on the LAN can access the Internet, even
installed with no PPPoE client software.
II. Networking Diagram
Figure 53 Access a LAN to the Internet via ADSL
III. Configuration Procedure
1 Configure a dialer interface
[Router]dialer-rule 1 ip permit
[Router]interface dialer 1
[Router-Dialer1]dialer bundle 1
[Router-Dialer1]dialer-group 1
command will permanently delete the session.
and command in all views.
debugging
Command
display pppoe-client session {
summary | packet }
[dial-bundle-number number ]
debugging pppoe-client option [
interface type number ]
PC PC
192.168.1.1 Eth0
RouterA
Eth1
ADSL Modem
Internet
PC
LAN