Networking Requirements - 3Com 3032 Configuration Manual

368 C 23: C
HAPTER ONFIGURING
Display and Debug IP
Count
Typical Configuration
Example
IP C
OUNT
The default max entries number of exterior is set to 0, namely, the packets that do
not match the rules will not be counted.
5 Configure Upper Threshold of Interior-List Accounting Entries
The following command is used for specifying count maximum of interior, that is,
the max entries number of the packets compliant with the IP Count lists.
Perform the following configuration in system view.
Table 403 Specify count maximum of interior
Operation
Specify count maximum of interior
Restore the default count maximum of interior
By default, the upper threshold of Interior-List entries is 512.
6 Configure Timeout of IP Count Entries
The following command is used for configuring timeout time for IP Count entries.
If no new packets are received within the timeout time, IP Count will assume that
the accounting entries have timed out and the accounting entries will be deleted
from the list.
Perform the following configuration in system view.
Table 404 Configure the period that an IP Count entry exists before it times out
Operation
Configure the timeout time of IP Count entries
Restore the default timeout time of IP Count entries undo ip count timeout
By default, IP Count entries time out after 720 minutes.
Table 405 Display and debug IP Count
Operation
Clear statistics of IP Count
Display IP Count lists
Display statistics of IP Count
Enable IP Count debugging at all levels
I. Networking Requirements
As shown in Figure 4-1, the router is connected to PC1 and PC2 via the interface
Ethernet0, and to PC3 and PC4 via Ethernet1. The router is required to make
statistics on the packets that the router transmitted to and received from PC1. PC1
is assigned with the address 169.254.10.1 and the mask 255.255.0.0.
Command
ip count interior-threshold
number
undo ip count
interior-threshold
Command
ip count timeout minutes
Command
reset ip count
display ip count table
display ip count {
inbound-packets |
outbound-packets } { exterior |
interior | firewall-denied }
debugging ip count [ data |
error ]