3Com 3032 Configuration Manual page 456

452 C 30: C
HAPTER ONFIGURING
BGP
Delete a BGP peer
BGP peer advanced configuration includes the following steps:
1 Configure the connection between EBGP peers that are connected indirectly.
Table 511 Configure Connection Between EBGP Peers Connected Indirectly
Operation
Configure connection between EBGP
peers connected indirectly
Return to the default BGP connections to
external peers
By default, the BGP connection can be established with a directly connected peer
router.
2 Configure the BGP version of the peer.
Table 512 Configure the BGP Version of the Peer
Operation
Configure the BGP version of the peer
Unconfigure the BGP version of the peer
By default, software accepts BGP Version 4.
3 Set the timers for the BGP peer.
Table 513 Set the Timers for BGP Peer
Operation
Set the timers for BGP peer
Set the timers for BGP peer to default
value
By default, the value of keepalive-interval is 60 seconds, the value of
holdtime-interval is 180 seconds.
Caution: The timer configured with this command is of higher preference than
that configured with the
4 Configure the BGP route-update interval.
Table 514 Configure BGP Route-update Interval
Operation
Configure BGP route-update interval
Restore BGP route-update interval
By default, the BGP route-update interval is 5 seconds.
5 Configure to send community attribute to the peer.
undo peer peer-address as-number
as-number
Command
peer peer-address ebgp-max-hop [
max-hop-count ]
undo peer peer-address ebgp-max-hop [
max-hop-count ]
Command
peer peer-address version
version-number
undo peer peer-address version
Command
peer peer-address timers
keepalive-interval holdtime-interval
undo peer peer-address timers
command.
timers
Command
peer peer-address
route-update-interval seconds
undo peer peer-address
route-update-interval