Configuring Networks For Bgp Distribution; Configuring Peers - 3Com 3032 Configuration Manual

Enabling BGP
Configuring Networks
for BGP Distribution

Configuring Peers

Configuring a BGP Community
Configuring a BGP AS Confederation Attribute
Configuring Route Dampening
Configuring Synchronization of BGP and IGP
Configuring the Interactions between BGP and an IGP
Defining an Access List Entry, an AS Path-list Entry, a Routing Policy
Configuring a Route Filter for BGP
Resetting BGP Connections
Specify the local AS number when BGP is enabled. After BGP is enabled, the local
router continuously monitors whether any incoming BGP connection request is
received from the peer routers. To make the local router send BGP connection
requests to the peer routers, use the
BGP protocol closes all BGP connections that have been created.
Perform the following configurations in system view.
Table 508 Enable BGP
Operation
Enable BGP and enter into the BGP view
Turn off the BGP
By default, BGP is disabled.
Perform the following configurations in BGP view.
Table 509 Configure Networks for BGP Distribution
Operation
Specify a list of networks associated with
BGP
Delete a list of networks associated with
BGP
By default, no network is configured for BGP distribution.
The routers that exchange BGP packets are called peers to each other. Peers can
be directly connected routers or indirectly connected routers but should be
connected by other directly connected router or routers.
BGP peer basic configuration includes setting the AS number of the peer.
Perform the following peer configuration in BGP view.
Table 510 Configure AS Number of the Peer
Operation
Configure AS number of the peer
Configuring BGP
command. When BGP is turned off,
peer
Command
bgp [ as-number ]
undo bgp
Command
network ip-address [ mask
address-mask ] [ route-policy
policy-name ]
undo network ip-address [ mask
address-mask ]
Command
peer peer-address as-number
as-number
451