Configuration Procedure - 3Com 3032 Configuration Manual

102 C 7: POS T
HAPTER ERMINAL
A S
CCESS ERVICE
9 Configure POS access interface FCM2
[Router] interface fcm2
[Router-FCM2] async mode pos 3
Configuration Example when the Router is Located at the FEP Side in
Asynchronous Connection Mode
I. Networking Requirements
Three POS terminals access the Router A located at the FEP side through the FCM
and connect to UNIX A (10.1.1.1) and UNIX B (11.1.1.1) in asynchronous
connection mode.
II. Networking Diagram
Figure 43 Networking diagram when the router is located at the FEP side in asynchronous
connection mode
POS
terminal
POS
terminal
POS
terminal
III. Configuration Procedure
1 Start the POS access server.
[Router] pos-server enable
2 Configure the POS application to UNIX A in asynchronous connection mode, the
connected interface is async 0, the application sequence number is 0.
[Router] pos-server app flow 0 async 0
3 Configure the POS application to UNIX B in asynchronous connection mode, the
connected interface is async 1, the application sequence number is 1.
[Router] pos-server app flow 1 async 1
4 Configure the POS multi-application mapping table (to map the packet whose
destination address is 01f1 to application 0).
[Router] pos-server map 01f1 0
5 Configure the POS multi-application mapping table (to map the packet whose
destination address is 01f2 to application 1).
[Router] pos-server map 01f2 1
6 Configure POS access interface FCM0.
[Router] interface fcm0
[Router-FCM0] async mode pos 1
7 Configure POS access interface FCM1.
[Router] interface fcm1
[Router-FCM1] async mode pos 2
8 Configure POS access interface FCM2.
[Router] interface fcm2
FCM
PSTN
Quidw ay
Router
10.1.1.1/24
UNIX A
11.1.1.1/24
A0
UNIX B
A1
11.1.1.2/24
11.1.1.1/24