Transparent Bridging; Networking Requirements; Display And Debug - 3Com 3032 Configuration Manual

Display and Debug

Bridge
Typical Bridge
Configuration

Transparent Bridging

Multiple LANs
Table 349 Configure bridge on VLAN
Operation
Configure the bridge-set on the sub-interface
of VLAN
Perform the ,
reset display
Table 350 Display and debug bridge
Operation
Clear the statistics of access list rules
Clear the entries of all the bridge-sets or
specified groups in the forwarding database
Clear the statistics of Spanning Tree
Clear the traffic statistics of bridge-set on the
interface
Display the states of all the bridge-sets
Display the information in the bridge
forwarding database
Display the state and statistics of STP
Display the static data of bridge-set traffic on a
port
Display the routing and bridging configuration
on each interface
Display link set configuration of the specified
bridge set.
Enable bridge-set debugging
Enable the spanning-tree protocol debugging debugging stp { error | event |
I. Networking Requirements
Suppose that there are several PCs located on the Ethernet segment LAN1 of a
building's floor and several PCs and servers on the Ethernet segment LAN2 of
another floor of the building. It is required to build the transparent bridge
between these two LANs.
Command
bridge-set bridge-set
and commands in all views.
debugging
Command
reset acl counters [ acl-number ]
reset bridge [ bridge-set ]
reset stp statistics
reset bridge traffic
display bridge-set [ bridge-set ]
display bridge information
display bridge spanning-tree
display bridge traffic
display bridge bridge-set
bridge-template
display bridgebridge-set link-set
debugging bridge
packet }
Display and Debug Bridge 307