3Com 3032 Configuration Manual page 728

724 C 51: C
HAPTER ONFIGURING
DCC
Operation
Configure the callback user and callback
number
Configure the local end to be the PPP
callback server
Disable the local end to be the PPP
callback server
Configure the PPP callback reference
Disable the callback server function of the
router
Configure the destination address(es) and
dial number(s) for calling one (or more)
remote ends
By default, the system does not enable the callback function. Once it is enabled,
the server will originate return calls according to the user name configured in the
command.
dialer route
If the callback client adopts the dynamically assigned network address, the server
will be unable to use the
number to associate with the network address. In this case, the callback client can
only use the
local-user callback-number
number to associate with the callback user name, and hence determine the
callback reference.
Configuring PPP callback in the resource-shared DCC implementation
1
Configure the PPP callback client in the resource-shared DCC implementation
As a callback client, a router can originate calls to the remote end (which can be a
router or Windows NT server having the PPP callback server function), and receive
the return calls from the remote end.
When resource-shared DCC are used to implement PPP callback, the PPP
authentication configuration at client end is the same as that of circular DCC,
except that the client in resource-shared DCC implementation must use the
command to configure a dial number. See "Configure PPP
dialer number
callback client in the circular DCC implementation" in Dial-up.
Perform the following configuration in dialer interface view.
Table 759 Implement PPP Callback (Client Configuration) in Resource-Shared DCC
Operation
Configure the local end to be the PPP
callback client
Disable the local end to be the PPP
callback client
Configure the dialer number for calling a
remote end
Configure the dial number for a Windows
NT server to originate return calls to the
router
Delete the dial number that a Windows
NT server needs for placing return calls to
the router
Command
local-user username callback-number
telephone-number
ppp callback server
undo ppp callback server
dialer callback-center [ user ] [
dial-number ]
undo dialer callback-center
dialer route protocol
next-hop-address user username
dial-number
command to configure a callback dial
dialer route
command to configure a callback dial
Command
ppp callback client
undo ppp callback client
dialer number dial-number
ppp callback ntstring dial-number
undo ppp callback ntstring