3Com 3032 Configuration Manual page 40

36 C 3: S M
HAPTER YSTEM ANAGEMENT
3: 38400 bps
4: 57600 bps
5: 115200 bps
6: Exit and Reboot
Enter your choice(1-6):
Make your selection as needed.
5 After a baud rate (115200 bps for example) is selected, the system displays the
following information to prompt you to modify the baud rate and select the
XModem protocol:
Download speed is 115200 bps. Change the terminal's speed to
115200 bps, and select XMODEM protocol. Press ENTER key when ready.
Perform the operation as prompted to change the baud rate set on the terminal
into the baud rate selected for software downloading.
Figure 17 Modify the terminal baud rate
Click OK after setting the new terminal baud rate. Click Disconnect and then
Connect in the terminal interface to proceed to the next step.
You must disconnect and connect the terminal emulation program after modifying
the baud rate of the terminal. Otherwise, the new baud rate cannot take effect.
6 The router displays the following, indicating that the system is waiting for loading:
Now Downloading Program File.
Please Start Transfer Program File Use Xmodem Protocol.
If You Want To Exit Press <Ctrl+X>.
Downloading...CCCCCCCCCC
Select [Transfer File] in the terminal emulation program menu and the following
dialog box displays: