3Com 3032 Configuration Manual page 752

748 C 51: C
HAPTER ONFIGURING
DCC
Message
DCC: peeraddr matching
on interface ***, shutdown link
DCC: idle-timeout on interface
*** , shutdown! start
enable-time
DCC: wait-for-carrier-timeout
on a link on interface ***,
shutdown!start enable-time
DCC: The interface has no
dialer-group, discard the
packet!
DCC: there is not a dialer
number on the interface,
failed, discard packet
DCC: Enable-timeout is
effective , failed
Fault
The debugging information is probably outputted
error
because the local dialer route does not contain the
remote network address. To solve the problem, add
the dialer route corresponding to the remote
network address on the local router or use the dial
number after removing all the dialer routes
configured on the local router.
The debugging information does not indicate any
error. DCC normally disconnects the connection,
because the local DCC idle-timeout timer has been
timed out.
The debugging information is probably outputted
because the local router cannot contact the remote
end for a long time. It may occur because the
remote end is busy or the quality of the phone line
is bad.
The debugging information is probably outputted
because the dialer-group command has not been
configured on the corresponding dialer interface or
the physical interface on which DCC is directly
enabled. To solve the problem, refer to the previous
example to make the configuration.
The debugging information is probably outputted,
because neither dialer route nor the dialer
number is configured on the corresponding dialer
interface or the physical interface on which DCC is
enabled directly. To solve the problem, configure
the dialer route and the dialer number on the local
end for the outbound call at the local end.
Rather than indicating an error, the outputted
debugging information means that the
enable-timeout timer on the corresponding physical
interface have not timed out yet. The physical
interface can be used for dialing upon the timeout
of the timer.