3Com 3032 Configuration Manual page 284

280 C 17: C
HAPTER ONFIGURING
Configuration Example
of Frame Relay Traffic
Shaping
Typical Frame Relay over
IP Configuration
Example
F R
RAME ELAY
[Router-fr-class-frts]cir allow 64000 64000
[Router-fr-class-frts]cbs 64000
[Router-fr-class-frts]cir 64000
[Router-fr-class-frts]fragment 80 data-level
I. Configuration Requirements
The Router is connected to the Frame Relay network via the interface Serial 0. It is
required that the average transmit rate of the router should be 96 kbps, the
maximum transmit rate should be 128 kbps, and the minimum transmit rate
should be 32 kbps, and at the same time, the router should own the function of
adaptive traffic adjustment. In addition, PQ is required to be adopted to ensure
that all the IP packets from the segment 10.0.0.0 will pass first.
II. Networking Diagram
Figure 97 Networking diagram of Frame Relay traffic shaping
Quidway
Router
III. Configuration Procedure
1 Define priority queue Group 1, and request all the IP packets from the segment
10.0.0.0 can pass first.
[Router]acl 1
[Router-acl-1]rule normal permit source 10.0.0.0 0.0.0.0
[Router]qos pql 1 protocol ip acl 1 queue top
2 Create a Frame Relay class and configure the parameters of Frame Relay traffic
shaping.
[Router]fr class 96k
[Router-fr-class-96k]cir allow 96000
[Router-fr-class-96k]cir 32000
[Router-fr-class-96k]cbs 96000
[Router-fr-class-96k]ebs 32000
[Router-fr-class-96k]traffic-shaping adaptation becn
[Router-fr-class-96k]pq pql 1
3 Configure the interface Serial 0 and enable the Frame Relay traffic shaping.
[Router]interface serial 0
[Router-Serial0]link-protocol fr
[Router-Serial0]ip address 1.1.1.1 255.255.255.0
[Router-Serial0]fr traffic-shaping
4 Create a Frame Relay PVC and associate the Frame Relay class with it.
[Router-Serial0]fr dlci 16
[Router-fr-dlci-16]fr-class 96K
I. Networking Requirements
Two Frame Relay networks are interconnected via RouterA and RouterB, which are
connected via an IP network. Enable Frame Relay over IP on the two routers to
interconnect these two Frame Relay networks over the IP network.
S0
CIR ALLOW = 96kbps
DTE
EIR = 32kbps
CIR = 32kbps
Frame Relay
Network