3Com 3032 Configuration Manual page 185

Assign an IP address to the interface
Configures a dialer bundle on the
interface
Assigns the interface to a dialer group
Depending on the needs, it is probably required to configure the parameters such
as PPP authentication on a dialer interface. The dialer interface configuration will
not be covered in this section, however. Please see Operation Manual - Dial-up for
reference.
2 Configure PPPoE Session
Perform the following configuration in Ethernet interface view.
Table 214 Configure PPPoE session
Operation
Configure a PPPoE session (permanently
online)
Configure a PPPoE session (triggered by
packets)
Delete the PPPoE session
The 3Com Router support two types of PPPoE connections, which are permanent
connections and packet-triggered connections.
In permanent connection, the router will originate a PPPoE call to automatically
and immediately set up a PPPoE session. And this session will be always in place
unless the user uses the
In packet-triggered connection, the router will not originate a PPPoE call
immediately. Instead, the router will originate a PPPoE call to establish a PPPoE
session only when there is data waiting for transmission. And the router will
automatically terminate the PPPoE session if the PPPoE link has been idle for
the specified period.
3 Reset or delete PPPoE Session
Perform the
reset pppoe-client
command in Ethernet interface view.
pppoe-client
Table 215 Reset or delete PPPoE session
Operation
Reset a PPPoE session but it will be re-established
later
Delete a PPPoE session and it will not be
re-established
The commands
reset pppoe-client
that the former only resets a PPPoE session temporarily whereas the latter deletes
a PPPoE session permanently.
If a permanent PPPoE session has been reset by executing the
command, the router will automatically re-establish the PPPoE
pppoe-client
session 16 seconds later. If a packet-triggered PPPoE session has been reset by
executing the same command, however, the router will re-establish the session
only when there is data waiting for transmission.
ip address { address mask |
ppp-negotiate }
dialer bundle bundle-number
dialer-group group-number
Command
pppoe-client dial-bundle-number number
[ no-hostuniq ]
pppoe-client dial-bundle-number number
[ no-hostuniq ] idle-timeout seconds [
hold-queue packets ]
undo pppoe-client dial-bundle-number
number
command to delete it.
undo pppoe-client
command in all views and the
Command
reset pppoe-client { all
|dial-bundle-number number }
undo pppoe-client
dial-bundle-number number
and
undo pppoe-client
Configure PPPoE Client 181
undo
differ in the sense
reset