3Com 3032 Configuration Manual page 383

Table 423 Configure the delay of interface sending IPX packets
Operation
Configure the Delay of Interface Sending IPX Packets
Restore default value of interface delay
By default, the delay of Ethernet interface is 1 tick, For asynchronous serial port is
30 ticks and that for WAN port is 6 ticks. The range of ticks is: 0~30000.
8 Configure Management of IPX Packet
By default, the router usually discards the broadcast packet of type 20, but you
can also enable such packet to be sent to other network segments by configuring
routers.
Perform the following task in interface view.
Table 424 Configure management of IPX packet
Operation
Enable propagation of broadcast packet of type 20
Disable propagation of broadcast packet of type 20
9 Modify Encapsulation Format of IPX Frame on Interface
E ncapsulation format of IPX frame
Table 425
Interface type
Ethernet interface
WAN interface
Perform the following task in interface view.
Table 426 Modify encapsulation format of IPX frame on interface
Operation
Modify encapsulation format of IPX frame on an
interface
Restore default value of encapsulation format of IPX
frame on an interface
By default, the encapsulation format of IPX frame on Ethernet interface is Ethernet
802.3, and that on WAN interface is PPP.
10 Configure IPX on WAN
In the 3Com Router series, commands such as
, can be used to configure mapping from IPX address to link layer address, so
map
as to run IPX on WAN. For detailed configurations, refer to relative chapters in
Link Layer Protocol.
Configure IPX
Command
ipx tick ticks
undo ipx tick
Command
ipx netbios-propagation
undo ipx netbios-propagation
Encapsulation format supported
Ethernet_SNAP
Ethernet_II
802.3
802.2
PPP
FR
X.25
Command
ipx encapsulation [ dot3 |
dot2 | ethernet-2 | snap ]
undo ipx encapsulation
,
dialer route fr map
379
and
x25