Command Line Error Message - 3Com 3032 Configuration Manual

24 C 2: 3C R
HAPTER OM OUTER
Command Line Error
Message
U I
SER NTERFACE
The help information obtained via the above-mentioned online help is
described as follows:
1 Full help: Enter "?" in any view, all the commands in this view and their brief
descriptions can be obtained.
[Router]?
aaa-enable Enable AAA(Authentication, Authorization and Accounting)
acl Specifystructure of access-list configure information
arp Add a ARP entry
bgp Enable/disable BGP protocol
bridge Bridge Set
clock Set system clock
copy Copy config or system file to remote tftp server
configfile Select config file stored in flash or NVRAM
controller Set a E1/T1 entry
......
2 Partial help: Enter a command followed by "?" separated with the space key, and
if parameters are available, descriptions of related parameters will be listed.
[Router]display ?
aaa
aaa-client
acl
arp
bgp
bridge
......
3 Partial help: Enter a character string followed by "?", and descriptions of all the
commands beginning with this character string will be listed.
[Router]di?
dialer dialer-rule
4 Partial help: Enter a command and a character string, followed by "?", and all the
key words beginning with this character string will be listed.
For example:
[Router]display a?
aaa aaa-client
In the 3Com Router, all the commands entered by users will be accurately
executed if they pass the syntax check. Otherwise, users will be informed by an
error message. The following table shows common error messages.
Table 5 List of common command line error messages
Common error
message
Incorrect command
Incomplete command
Invalid parameters
Too many parameters
AAA information
Display the buffered voice information
Display access-list information
ARP table information
BGP protocol information
Remote bridge information
display
acl arp
Causes
No command has been found.
No key word has been found.
Wrong parameter type
The command input is incomplete.
Parameter value beyond limit
Too many parameters are input.