3Com 3032 Configuration Manual page 96

92 C 6: D
HAPTER ISPLAY AND
Display and Debug
Syslog
Typical Syslog
Configuration Example
D T
EBUGGING OOLS
Set terminal Filter
Delete terminal Filter
Set Filter of internal buffer
Delete Filter of terminal buffer
Set Filter of log host
Delete Filter of log host
Here, module stands for the module name. Only the log information related to a
specified module can be filtered and output.
Turn on/turn off syslog
Please enter the following commands in system view.
Table 70 Turn on/turn off syslog
Operation
Turn on Syslog
Turn off Syslog
When Syslog is turned on, the performance of the system will be affected due to
the information classification and output - especially when processing a large
amount of information.
Perform the following configuration in all views.
Table 71 Display and debug syslog
Operation
Display basic configuration information of Syslog display info-center
Display internal buffer information of Syslog
Configuration of Log Host
The configuration, implemented on SunOS 4.0, is almost the same as that
performed on the Unix operating system of other manufacturers.
1 Execute following commands as root (supervisor)
#mkdir
#touch
#touch
2 Edit the file
/etc/syslog.conf
pairs.
#Router configuration messages
Local4.crit /var/log/Router/config
When editing /etc/syslog.conf, note the following:
The comments can only be in separate lines, beginning with character #.
The selector/action pairs must be separated with one Tab instead of a space.
There must not be redundant spaces behind the file name.
info-center monitor filter module
undo info-center monitor filter
info-center logbuffer filter module
undo info-center logbuffer filter
info-center loghost <0-9> { local<0-7>
| ip-address } filter module
undo info-center loghost <0-9> {
local<0-7> | ip-address } filter
Command
info-center enable
undo info-center enable
/var/log/Router
/var/log/Router/config
/var/log/Router/security
as the root and add the following selector/action
Command
display info-center logbuffer