3Com 3032 Configuration Manual page 48

44 C 3: S M
HAPTER YSTEM
Back up the 3Com
Router Main Program
Software
ANAGEMENT
7 At the prompt
ftp>
command to display the file name and size on the router. If the uploading
operation is successful, the program or configuration file on the router and the
uploaded file on the host should have the same size.
8 At the prompt
ftp>
9 The router writes the files into the Flash after receiving all of them, and the
following information displays on the terminal:
Now saving the program file.
Please wait for a while
Receive
Writing program code to FLASH...
Please waiting, it may take a long time (about 10 min)
####################################################################
############
####################################################
Write success, please reboot router!
The upgraded software can only take effect after rebooting the router.
TFTP Approach
With this approach, you can use the
main software to the TFTP server for redundancy, after booting the router.
Start the TFTP server and connect it with the router before using this method to
back up the 3Com Router main software. Then, execute the following command
in system view.
Table 19 Download configuration files from a TFTP server
Operation
Copies the 3Com Router main software to a
TFTP server for redundancy
FTP Approach
The procedure of backing up the 3Com Router main program software with FTP is
the same as loading the software with FTP, except for step 6. See "FTP Approach"
on page 41 for reference. When backing up the software with FTP, however, the
step 6 described in "FTP Approach" on page 41 should be modified as follows:
At the prompt
ftp>
the specified file to the router. RemoteFile should use the name of the system file
on the router, and the name is case sensitive. You can use the
command to modify the file name on the router. For details, refer to
config-name
"FTP Approach" on page 44.
ftp> get config config.bak
200 Port command okay.
150 Server okay , now transmit file .
226 file transmit success.
ftp: 5802263 bytes received in 80.74Seconds 71.86Kbytes/sec.
, appearing after the file uploading is completed, enter the
, enter the command to exit the FTP client program.
quit
5802263 Bytes from client
copy
Command
copy ip-addr file-name system
, use the
get RemoteFile [LocalFile]
command to copy the 3Com Router
command to upload
ftp-server
dir